Decorative window film is very easy to apply.
For large sizes (such as for sliding doors), we recommend that two people work together to perform the installation. Besides, it will be fun!
TIPS BEFORE YOU BEGIN
SHOWER ENCLOSURES:
Install the decorative window film on the outside of shower stall. Steam and moisture will not affect our products.
THERMAL PANE WINDOWS:
Install on outside of window or allow a 1/4" border between edge of glass and product.
- Measure size of glass, allowing a 1/4" border.
- Draw desired size/shape on backing paper.
- Trim with scissors or utility knife.
- Clean glass with soap and water before applying window film.
STORAGE:
When not in use, window film must be replaced and stored on the original backing paper. Film adheres to the glossy side of the backing paper.
INSTALLATION OVERVIEW
Clean glass.
Nettoyez le verre.
Limpie el vidrio.
Wet glass with soapy water.
Mouillez le verre avec de l'eau savonneuse.
Humedezca el vidrio con agua jabonosa.
Remove from backing paper.
Retirez la pellicule protectrice.
Quite la pel”cula del papel protector posterior.
Apply to wet glass and smooth with hands.
Appliquez sur le verre mouill? et lissez avec la main.
Apl”quela al vidrio h£medo y al”selo con la mano.
Squeegee away water and air bubbles. (Squeegee included.)
Utilisez la raclette (incluse) pour retirer l'eau et les bulles d'air.
Use el Squeegee gratuito (suministrado) para eliminar las burbujas de agua y aire.
STEP-BY-STEP INSTALLATION INSTRUCTIONS
Window film is installed on the room side of your glass doors. The side of the film contacting the backing paper is applied to the glass.
-
Clean glass well.
It is very important that the glass be free of debris and the surface completely smooth.
TIP: Use a scrapper or razor blade to remove any paint splatters or hard materials that might be stuck to the surface.
-
Wash Your Hands
This prevents dirt and oils from getting between the film and the glass as you apply it.
-
Wet glass completely.
Completely wetting the glass makes it easier to position the film & squeegee out air bubbles.
TIP: Use a spray bottle with water and a few drops of liquid soap. Set spray bottle to a mist setting and thoroughly wet glass.
-
Remove film from backing paper and position on glass.
Try not to let the backing-free film touch anything else, as it might collect dust and dirt from other surfaces.
TIP: Use the side of your hand to smooth out any large bubbles. The film will then "float" on the glass for you to move into its final position.
-
Squeegee out all air bubbles.
TIP: It is easier to squeegee out air bubbles if you wet the front of the film, with your soapy solution, before squeegeeing.
If an edge of the material tries to roll up and will not lie flat, use a hair dryer on a low heat setting to warm the material until it becomes pliable. Turn off heat and hold in place for 60-90 seconds or until material cools to room temperature.
